Elenos Broadcast Experience - Echos3 Telemetry

Echos3 Telemetry

The telemetry can be connected to equipment of any other broadcast producer through analogue or digital inputs/outputs, or to the brand new generation of Elenos equipment via its RS 485 port.

It is provided with 8 digital inputs, 8 analog inputs, 8 outputs dry contacts relay outputs, GSM modem, battery, Battery charger, led bar visualizing the GSM signal level, RS232 and RS485 ports.

The user can see parameters and give commands to the equipment via connection between Modem and PC and via SMS.

Name, scale and alarm threshold of parameters are programmable through linear or logarythmic conversion, therefore any tipe of parameter can be seen in perfect scale: Voltage, Amperage, Power, Temperature etc.

ECHOS_Telemetri_Dietro_HD [320x200].jpg

All inputs are programmable to generate and send SMS alarms. For example, the user can program the telemetry to send an alarm when the transmitter power goes under a set threshold, when the site door is open or it temperature on site is too high and so on.

The outputs can be programmed at dry contacts normally open or closed, or at negative or positive impulse.

The connection to PC is made using Windows standard Hyperterminal, therefore it is not only intuitive and easy-to-use, but also there is no need of a specific software installation. It uses a ASCII protocol and it's easily adaptable to other producers' software.

Thank to the internal battery, it sends an SMS in case of mains interruption.

A led bar on the front panel indicates the signal level of the GSM modem thanks to which it is easy to adjust the antenna for a better reception.

Login