Telemetry

Elenos telemetry can be connected to any other broadcast producer equipment , through analogue or digital inputs/outputs, or to new generation Elenos equipment through RS 485 port.

It is provided with 8 digital inputs, 8 analog inputs, 8 outputs to relay to dry contacts, modem quadriband, battery, battery charger, led bar (visualizing the GSM signal level) RS232 and RS485 ports.

The user can see parameters and can give commands through connection between Modem and PC and through SMS.

The connection to PC is made using Windows Hyperterminal standard, therefore it is not only intuitive and easy-to-use, but also there is no need of a specific software installation. It uses an ASCII protocol.

Parameters name, scale and alarm threshold are programmable through linear or logarithmic conversion, therefore any type of parameter can be seen in perfect scale (Voltage, Amperage, Power, Temperature etc.)

All inputs are programmable. The advantages are a lot : for example, the user can program the telemetry to send an alarm when the transmitter power goes under a set threshold, when the site door is open or when temperature on site is too high, and so on.

The outputs can be programmed through dry contacts normally open or closed, or at negative or positive impulse.

Thank to the internal battery, it sends an SMS in case of an interruption.

Telemetry

Telemetry